Technical data sheets
Aluminium Alloy | BS-L
3L54 Tube
Applications:
Drawn Tube
Characteristic Properties:
Very good atmospheric corrosion resistance and workability. High thermal conductivity and reflectivity but lower than for 1050A. Very good weldability. Slightly higher strength than 1050A.
Chemical Composition
|
BS 4L54(1986) Alloy 3L54 |
|
|---|---|
| Chemical Element | % Present |
| Manganese (Mn) | 0.05 max |
| Titanium (Ti) | 0.05 max |
| Copper (Cu) | 0.05 max |
| Other (Each) | 0.05 max |
| Zinc (Zn) | 0.1 max |
| Others (Total) | 0.15 max |
| Silicon + Iron (Si+Fe) | 1 max |
| Aluminium (Al) | 99 min |
The tube shall be supplied cold drawn.
Alloy Designations
Aluminium alloy 3L54 - 1200 is covered by Standard BS EN 4L54 (1986)
Temper Types
The most common tempers for 3L54 - 1200 aluminium is cold drawn
Supplied Forms
3L54-1200 aluminium is supplied as cold drawn tube
- Tube
Generic Physical Properties
| Physical Property | Value |
|---|---|
| Density | 2.59 g/cm³ |
| Melting Point | 657 °C |
| Thermal Expansion | 23.4 x10^-6 /K |
| Modulus of Elasticity | 69 GPa |
| Thermal Conductivity | 225 W/m.K |
| Electrical Resistivity | 58.5 % IACS |
Mechanical Properties
|
BS 4L54(1986) Seamless Tube - Up to and inc. 75mm OD |
|
|---|---|
| Mechanical Property | Value |
| Tensile Strength | 125 Min MPa |
The tensile value shown relates to tubes with a nominal outside diameter up to and including 75mm. The value for over 75mm shall be 110 N/mm2. Tubes shall be subjected to a single drifting test, a bore test and a hydraulic test according to the formula shown in the specification.
Download PDF
Last updated Tuesday, January 7, 2014
Disclaimer
This Data is indicative only and as such is not to be relied upon in place of the full specification. In particular, mechanical property requirements vary widely with temper, product and product dimensions. All information is based on our present knowledge and is given in good faith. No liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.
Please note that the 'Datasheet Update' date shown above is no guarantee of accuracy or whether the datasheet is up to date.
The information provided in this datasheet has been drawn from various recognised sources, including EN Standards, recognised industry references (printed & online) and manufacturers’ data. No guarantee is given that the information is from the latest issue of those sources or about the accuracy of those sources.
Material supplied by the Company may vary significantly from this data, but will conform to all relevant and applicable standards.
As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose, whether expressed or implied.
Advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. All transactions are subject to the Company’s current Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.